Effect of Toluene on PEMFC Performance

AbstractLiquid organic hydrogen carriers (LOHCs) are promising means for hydrogen transportation. They are compatible with existing liquid fuel transport infrastructure and enable for efficient and safe hydrogen storage and transfer over long distances. Toluene and dibenzyltoluene are considered the two most promising LOHCs. Toluene is probably a contaminant found in hydrogen released from these LOHC liquids.The impact of hydrocarbon contaminants on automotive type fuel cells has been analyzed to a limited extent, and a few species only have specific limits (CO, CO2, HCOOH, HCHO, CH4). Currently, hydrocarbons are limited to a total of 2 ppm (methane basis) in the automotive hydrogen fuel standard, ISO 14687:2019. This may lead to strict impurity levels for species from LOHC, and therefore higher costs of hydrogen purification and quality assurance.This work presents contamination studies with toluene. The measurements were conducted using a PEMFC short stack with anode recirculation and with high fuel utilization (98%). The results show no effect or only a small contamination effect with up to 20 ppm toluene, and clear contamination with 50 ppm toluene. This supports the need for more studies so that a separate limit can be defined for toluene in future versions of the ISO 14687

Effect of fuel utilization on the carbon monoxide poisoning dynamics of Polymer Electrolyte Membrane Fuel Cells

The effect of fuel utilization on the poisoning dynamics by carbon monoxide (CO) is studied for future automotive conditions of Polymer Electrolyte Membrane Fuel Cells (PEMFC). Three fuel utilizations are used, 70%, 40% and 25%. CO is fed in a constant concentration mode of 1 ppm and in a constant molar flow rate mode (CO concentrations between 0.18 and 0.57 ppm). The concentrations are estimated on a dry gas basis. The CO concentration of the anode exhaust gas is analyzed using gas chromatography. CO is detected in the anode exhaust gas almost immediately after it is added to the inlet gas. Moreover, the CO concentration of the anode exhaust gas increases with the fuel utilization for both CO feed modes. It is demonstrated that the lower the fuel utilization, the higher the molar flow rate of CO at the anode outlet at early stages of the CO poisoning. These results suggest that the effect of CO in PEMFC systems with anode gas recirculation is determined by the dynamics of its accumulation in the recirculation loop. Consequently, accurate quantification of impurities limits in current fuel specification (ISO 14687-2:2012) should be determined using anode gas recirculation